Nox A1 Online - Sentec Setup

The Sentec™ has a serial output and a LAN output on the back of the device. It is therefore possible to connect to the Nox Sleep System using two methods

1. Via Nox C1 Access Point using a standard RS-232 to 3.5mm jack serial cable from the serial port
2. Connecting the Sentec LAN output to the same local network as the Nox C1 Access Point is connected to.

The two setup possibilities for the Sentec can be seen on the images below:

1)

2)

The following items are needed for the Nox Sleep System setup with a Sentec

Setup 1)

• Sentec Device ("SentecLink" communication protocol)
• Nox C1 Access Point and a power supply*
• Ethernet Cable
• RS232(male) to standard 3.5mm jack cable
• Null Modem (orange)
• PC Computer**

Setup 2)

• Sentec Device ("SentecLink" communication protocol)
• Nox C1 Access Point and a power supply*
• 3x Ethernet Cables
• Switch
• PC Computer**

Instructions on how to set up an online room in the Noxturnal Software and how to start an online recording be found here.

Instructions on how to add auxiliary devices into online rooms in Noxturnal can be found here.

*Warning: Only use power supply FRIWO MP115 Medical-7555M/12 with the C1 device. The use of an incorrect power supply may result in electric shock or cause the device to overheat, which may result in patient/operator harm.

** Warning: The computer used must comply with the international standard IEC 60950-1 for the safety of information technology equipment.

For further information please contact support@noxmedical.com  

 

                                                                                                                                Rev.002